Lưỡi cắt acrylic – Acrylic saw blade

Applicable materials A variety of acrylic sheet saw blade use precautions:
1. Please hang the alloy saw blade vertically on a dry shelf. Be sure to avoid the wet place. Never place the alloy saw blade on the ground or on the shelf. Flattening will cause the alloy saw blade to deform.
2. Do not exceed the specified maximum speed when using. The speed calculation method is attached for reference.
3. Wear, protective gloves, gloves, safety shoes, safety glasses, and safety glasses.
4. When installing the alloy saw blade, you must first confirm the performance and use of the saw table. It is best to read the instructions of the saw table first. In order to avoid mistakes, causing accidents.
5. When installing the alloy saw blade, it is necessary to check whether the alloy saw blade has cracks, distortion, flattening, tooth loss, etc., and then install it.
6. The saw blade of the alloy saw blade is super hard and sharp, and it is forbidden to collide and fall off the ground. It must be handled gently.
7. After installing the alloy saw blade, you must confirm that the center hole of the saw blade is firmly fixed on the flange of the saw table. When the washer is installed, the washer must be set. Then, gently push the saw blade by hand to confirm the saw blade rotation. Is it eccentric?
8. The cutting direction indicated by the arrow of the alloy saw blade must be aligned with the direction of rotation of the saw table. It is strictly forbidden to install the reverse direction. If the direction is incorrectly installed, the tooth will be lost.
9. Pre-rotation time: After replacing the alloy saw blade, it needs to be pre-rotated for one minute before use, and the cutting table can be cut when it enters the working state.